Link Aggregation Status - ZyXEL Communications XMG1930-30 User Manual

operational port fails, then one of the "standby" ports become operational without user intervention.
Please note that:
• You must connect all ports point-to-point to the same Ethernet switch and configure the ports for
LACP trunking.
• LACP only works on full-duplex links.
• All ports in the same trunk group must have the same media type, speed, duplex mode and flow
control settings.
Configure trunk groups or LACP before you connect the Ethernet switch to avoid causing network
topology loops.
Link Aggregation ID
LACP aggregation ID consists of the following information
Table 103 Link Aggregation ID: Local Switch
SYSTEM PRIORITY
0000
Table 104 Link Aggregation ID: Peer Switch
SYSTEM PRIORITY
0000
Traffic Distribution Criteria
The Switch supports both unicast and non-unicast traffic (broadcast and multicast) network load sharing
over link aggregation. Load sharing works by statically splitting the traffic based on source or destination
IP/MAC address, and then distributing the load across multiple paths. In link aggregation, this allows the
trunk group (ports) to transmit data as one logical link to a single or group of hosts on the network.
Unicast and non-unicast traffic network load sharing over link aggregation (trunking) is enabled by
default.

34.2 Link Aggregation Status

Click PORT > Link Aggregation > Link Aggregation Status in the navigation panel to display the screen as
shown. See
1. Port Priority and Port Number are 0 as it is the aggregator ID for the trunk group, not the individual port.
Chapter 34 Link Aggregation
MAC ADDRESS
00-00-00-00-00-00
MAC ADDRESS
00-00-00-00-00-00
Section 34.1 on page 224
XMG1930 Series User's Guide
1
:
KEY PORT PRIORITY
0000 00
KEY PORT PRIORITY
0000 00
for more information.
225
PORT NUMBER
0000
PORT NUMBER
0000