Classifier; Chapter 67 Classifier; Classifier Overview; What You Can Do - ZyXEL Communications XMG1930-30 User Manual

30-port multi-gigabit smart managed layer-2 switch, 30-port multi-gigabit smart managed layer-2 poe switch
Table of Contents

Advertisement

67.1 Classifier Overview

This chapter introduces and shows you how to configure the packet classifier on the Switch. It also
discusses Quality of Service (QoS) and classifier concepts as employed by the Switch.

67.1.1 What You Can Do

• Use the Classifier Status screen
Switch and how many times the traffic matches the rules.
• Use the Classifier Setup screen
summary of the classifier configuration. After you define the classifier, you can specify actions (or
policy) to act upon the traffic that matches the rules.
• Use the Classifier Global Setting screen
enable logging on the Switch.

67.1.2 What You Need to Know

Quality of Service (QoS) refers to both a network's ability to deliver data with minimum delay, and the
networking methods used to control the use of bandwidth. Without QoS, all traffic data is equally likely
to be dropped when the network is congested. This can cause a reduction in network performance and
make the network inadequate for time-critical application such as video-on-demand.
A classifier groups traffic into data flows according to specific criteria such as the source address,
destination address, source port number, destination port number or incoming port number. For
example, you can configure a classifier to select traffic from the same protocol port (such as Telnet) to
form a flow.
Configure QoS on the Switch to group and prioritize application traffic and fine-tune network
performance. Setting up QoS involves two separate steps:
Configure classifiers to sort traffic into different flows.
1
Configure policy rules to define actions to be performed on a classified traffic flow (refer to
2
on page 480
You can also configure policy routing to forward a classified traffic flow to a different gateway for cost
savings and load sharing.

Chapter 67 Classifier

(Section 67.2 on page
(Section 67.3 on page
to configure policy rules).
XMG1930 Series User's Guide
C
H A P T E R
472) to view the classifiers configured on the
472) to define the classifiers and view a
(Section 67.4 on page
477) to configure the match order and
471

Classifier

Chapter 68
67

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xmg1930 series

Table of Contents