Reboot System - ZyXEL Communications XMG1930-30 User Manual

Table 326 MAINTENANCE > Firmware Upgrade (continued)
LABEL
File Path
Upgrade

78.16 Reboot System

Reboot System allows you to restart the Switch without physically turning the power off. It also allows you
to load configuration one (Config 1), configuration two (Config 2), a Custom Default or the Factory
Default configuration when you reboot. Follow the steps below to reboot the Switch.
Click MAINTENANCE > Reboot System to view the screen as shown next.
Figure 421 MAINTENANCE > Reboot System
Click the Config 1, Config 2, Factory Default, or Custom Default button to reboot and load that
1
configuration file. The confirmation screen displays.
Figure 422 Reboot Confirmation
Click YES and then wait for the Switch to restart. This takes up to 2 minutes.
2
Click Config 1 and follow steps 1 to 2 to reboot and load configuration one on the Switch.
Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the Switch.
Click Factory Default and follow steps 1 to 2 to reboot and load Zyxel factory default configuration
settings on the Switch.
Click Custom Default and follow steps 1 to 2 to reboot and load a customized default file on the Switch.
This will save the custom default configuration settings to both Configuration 1 and Configuration 2.
Note: If a customized default file was not saved, clicking Custom Default loads the factory
default configuration on the Switch.
Chapter 78 MAINTENANCE
DESCRIPTION
Click Choose File or Browse to locate the firmware file you wish to upload to the Switch.
Click Upgrade to load the new firmware. Firmwares are only applied after a reboot. To
reboot, go to MAINTENANCE > Reboot System and click Config 1, Config 2 or Factory
Default (Config 1, Config 2, Factory Default, and Custom Default are the configuration files
you want the Switch to use when it restarts).
XMG1930 Series User's Guide
576