Ipv6 Source Binding Status - ZyXEL Communications XMG1930-30 User Manual

75.8 IPv6 Source Binding Status

Use this screen to look at the current IPv6 dynamic and static bindings and to remove dynamic bindings
based on IPv6 address and/or IPv6 prefix. Bindings are used to distinguish between authorized and
unauthorized packets in the network. The Switch learns the bindings by snooping DHCP packets
(dynamic bindings) and from information provided manually by administrators (static bindings). To open
this screen, click SECURITY > IPv6 Source Guard > IP Static Binding > IP Source Binding Status.
Figure 380
The following table describes the labels in this screen.
Table 299 SECURITY > IPv6 Source Guard > IP Static Binding > IP Source Binding Status
LABEL
Clear Dynamic
Source Binding
Flush
Cancel
Index
Source Address
MAC Address
VLAN
Port
Lease
Type
Chapter 75 ARP Inspection
SECURITY > IPv6 Source Guard > IP Static Binding > IP Source Binding Status
DESCRIPTION
Specify how you want the Switch to remove dynamic IPv6 source binding entries when you
click Flush.
• Select All to remove all of the dynamic entries from the IPv6 source binding table.
• Select IPv6 Address and enter an IPv6 address to remove the dynamic entries snooped
with the specified IPv6 address.
• Select IPv6 Prefix and enter a Prefix address to remove the dynamic entries snooped with
the specified Prefix address.
Click this to remove dynamic IPv6 source binding entries according to your selections.
Click this to reset the values above based or if not applicable, to clear the fields above.
This field displays a sequential number for each binding.
This field displays the source IP address in the binding. If the entry is blank, this field will not be
checked in the binding.
This field displays the source MAC address in the binding. If the entry is blank, this field will not
be checked in the binding.
This field displays the source VLAN ID in the binding. If the entry is blank, this field will not be
checked in the binding.
This field displays the port number in the binding. If this field is blank, the binding applies to all
ports.
This field displays how many days, hours, minutes, and seconds the binding is valid; for
example, 2d3h4m5s means the binding is still valid for 2 days, 3 hours, 4 minutes, and 5
seconds. This field displays infinity if the binding is always valid (for example, a static binding).
This field displays how the Switch learned the binding.
S: This static binding was learned from information provided manually by an administrator.
DH: This dhcp-snooping binding was learned by snooping DHCP packets.
XMG1930 Series User's Guide
529