ZyXEL Communications XMG1930-30 User Manual page 371

Figure 255 SWITCHING > Spanning Tree Protocol > MSTP > MSTP Port Setup (Without Access L3 License)
Figure 256 SWITCHING > Spanning Tree Protocol > MSTP > MSTP Port Setup (With Access L3 License)
The following table describes the labels in this screen.
Table 193 SWITCHING > Spanning Tree Protocol > MSTP > MSTP Port Setup
LABEL DESCRIPTION
Port This field displays the port number. * means all ports.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Edge Select this check box to configure a port as an edge port when it is directly attached to a
computer. An edge port changes its initial STP port state from blocking state to forwarding
state immediately without going through listening and learning states right after the port is
configured as an edge port or when its link status changes.
Note: An edge port becomes a non-edge port as soon as it receives a Bridge
Chapter 53 Spanning Tree Protocol
Protocol Data Unit (BPDU).
XMG1930 Series User's Guide
371