ZyXEL Communications XMG1930-30 User Manual page 395

Table 208 SWITCHING > VLAN > Protocol Based VLAN Setup > Add/Edit (continued)
LABEL
Ethernet-type
VLAN
Priority
Apply
Clear
Cancel
56.10.1.1 Create an IP-based VLAN Example
This example shows you how to create an IP VLAN which includes ports 1, 4 and 8. Follow these steps
using the screen below:
Activate this protocol based VLAN.
1
Type the port number you want to include in this protocol based VLAN. Type 1.
2
Give this protocol-based VLAN a descriptive name. Type IP-VLAN.
3
Select the protocol. Leave the default value IP.
4
Type the VLAN ID of an existing VLAN. In our example we already created a static VLAN with an ID of 5.
5
Type 5.
Leave the priority set to 0 and click Apply.
6
Figure 280 Protocol Based VLAN Configuration Example
To add more ports to this protocol based VLAN.
Click the index number of the protocol based VLAN entry. Click 1.
1
Chapter 56 VLAN
DESCRIPTION
Use the drop down list box to select a predefined protocol to be included in this protocol
based VLAN or select Other and type the protocol number in hexadecimal notation. For
example the IP protocol in hexadecimal notation is 0800, and Novell IPX protocol is 8137.
Note: Protocols in the hexadecimal number range of 0x0000 to 0x05ff are not
allowed to be used for protocol based VLANs.
Enter the ID of a VLAN to which the port belongs. This must be an existing VLAN which you
defined in the SWITCHING > VLAN > VLAN Setup > Static VLAN screen.
Select the priority level that the Switch will assign to frames belonging to this VLAN.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XMG1930 Series User's Guide
395