ZyXEL Communications XMG1930-30 User Manual page 120

Table 34 DASHBOARD (continued)
LABEL DESCRIPTION
Registration This is the MAC address reserved for NCC registration. Use this MAC address to register the Switch
MAC
on NCC.
Address
Cloud Control This field displays:
Status
• The Switch Internet connection status.
• The connection status between the Switch and NCC.
• The Switch registration status on NCC.
Mouse over the circles to display detailed information.
To pass your Switch management to NCC, first make sure your Switch is connected to the
Internet. Then go to NCC and register your Switch.
Click Cloud Control Status or the switch button to go to the SYSTEM > Cloud Management
screen. You can enable/disable NCC Discovery or view the NCC connection status in the Cloud
Management screen.
1. Internet
Green – The Switch is connected to the Internet.
Orange – The Switch is not connected to the Internet.
2. Nebula
Green – The Switch is connected to NCC.
Orange – The Switch is not connected to NCC.
3. Registration
Green – The Switch is registered on NCC.
Gray – The Switch is not registered on NCC.
Note: All circles will gray out if you disable Nebula Discovery.
Note: If a circle displays orange or gray, hover the mouse over the circle to check the
diagnostic message.
NCC This displays if NCC discovery is enabled on the Switch. The Switch will connect to NCC and
Discovery
change to the NCC management mode if it:
• is connected to the Internet.
• has been registered on NCC.
CPU Usage This displays the current CPU usage percentage.
Click to go to the MONITOR > System Information screen to check the detailed information.
Memory Usage This displays the current RAM usage percentage.
Click to go to the MONITOR > System Information screen to check the detailed information.
PoE Usage For PoE models.
This field displays the amount of power the Switch is currently supplying to the connected PoE-
enabled devices and the total power the Switch can provide to the connected PDs. It also
shows the percentage of PoE power usage.
When PoE usage reaches 100%, the Switch will shut down PDs one-by-one according to the PD
priority which you configured in PORT > PoE Setup > PoE Setup.
Chapter 7 DASHBOARD
XMG1930 Series User's Guide
120