Port Utilization - ZyXEL Communications XMG1930-30 User Manual

Table 45 MONITOR > Port Status > DDMI > DDMI Details (continued)
LABEL
TX Bias (mA)
TX Power
(dbm)
RX Power
(dbm)
Current
High Alarm
Threshold
High Warn
Threshold
Low Warn
Threshold
Low Alarm
Threshold

15.3 Port Utilization

This screen displays the percentage of actual transmitted or received frames on a port as a percentage
of the Link speed. To view port utilization, click MONITOR > Port Status > Port Utilization to see the
following screen. Alternatively, click DASHBOARD from any Web Configurator screen and then the Port
Status link in the Quick Link section of the DASHBOARD screen to display the Port Status screen and then
click the Port Utilization link tab.
Figure 87 MONITOR > Port Status > Port Utilization
The following table describes the labels in this screen.
Table 46 MONITOR > Port Status > Port Utilization
LABEL
Port
Link
Tx kB/s
Chapter 15 Port Status
DESCRIPTION
This displays the milliamps (mA) being supplied to the SFP transceiver's Laser Diode Transmitter.
This displays the amount of power the SFP transceiver is transmitting.
This displays the amount of power the SFP transceiver is receiving from the fiber cable.
This displays the current status for each monitored DDMI parameter.
This displays the high value alarm threshold for each monitored DDMI parameter. An alarm
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
This displays the high value warning threshold for each monitored DDMI parameter. A warning
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
This displays the low value warning threshold for each monitored DDMI parameter. A warning
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
This displays the low value alarm threshold for each monitored DDMI parameter. An alarm
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
DESCRIPTION
This identifies the Ethernet port.
This field displays the speed (such as 100M for 100 Mbps, 1000M for 1000 Mbps, or 10G for 10 Gbps)
and the duplex (F for full duplex). This field displays Down if the port is not connected to any
device.
This field shows the transmission speed of data sent on this port in kilobytes per second.
XMG1930 Series User's Guide
145