Link Aggregation Control Protocol - ZyXEL Communications XMG1930-30 User Manual

30-port multi-gigabit smart managed layer-2 switch, 30-port multi-gigabit smart managed layer-2 poe switch
Table of Contents

Advertisement

Table 106 PORT > Link Aggregation > Link Aggregation Setting (continued)
LABEL
Criteria
Port
Group
Apply
Cancel

34.4 Link Aggregation Control Protocol

Click PORT > Link Aggregation > Link Aggregation Control Protocol to display the screen shown next. See
Dynamic Link Aggregation on page 224
Note: Do NOT configure this screen unless you want to enable dynamic link aggregation.
Chapter 34 Link Aggregation
DESCRIPTION
Select the outgoing traffic distribution type. Packets from the same source and/or to the same
destination are sent over the same link within the trunk. By default, the Switch uses the src-dst-mac
distribution type. If the Switch is behind a router, the packet's destination or source MAC address
will be changed. In this case, set the Switch to distribute traffic based on its IP address to make
sure port trunking can work properly.
Select src-mac to distribute traffic based on the packet's source MAC address.
Select dst-mac to distribute traffic based on the packet's destination MAC address.
Select src-dst-mac to distribute traffic based on a combination of the packet's source and
destination MAC addresses.
Select src-ip to distribute traffic based on the packet's source IP address.
Select dst-ip to distribute traffic based on the packet's destination IP address.
Select src-dst-ip to distribute traffic based on a combination of the packet's source and
destination IP addresses.
This field displays the port number.
Select the trunk group to which a port belongs.
Note: When you enable the port security feature on the Switch and configure port
security settings for a port, you cannot include the port in an active trunk group.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XMG1930 Series User's Guide
for more information on dynamic link aggregation.
228

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xmg1930 series

Table of Contents