Mitsubishi Electric 800 Series Instruction Manual page 641

 32-bit data
No.
H0200 reserved
H0201 Output frequency (0-15bit)
H0202 Output frequency (16-31bit)
H0203 Setting frequency (0-15bit)
H0204 Setting frequency (16-31bit)
H0205 Motor rotation (0-15bit)
H0206 Motor rotation (16-31bit)
H0207 Load meter (0-15bit)
H0208 Load meter (16-31bit)
H0209, reserved
H020A
H020B Watt-hour meter (1kWh step) (0-15bit)
H020C Watt-hour meter (1kWh step) (16-31bit)
H020D Watt-hour meter (0.1/0.01kWh step) (0-15bit)
H020E Watt-hour meter(0.1/0.01kWh step) (16-31bit)
H020F to reserved
H03FF
 Waiting time for the communication line error output after a
communication error
Waiting time for the communication error output after a communication line error occurrence can be set.
Pr.
500 Communication error execution waiting time
Communication line status
When a communication line error occurs and lasts longer than the time set in Pr.500, it is recognized as a communication error.
If the communication returns to normal within the time, it is not recognized as a communication error, and the operation
continues.
NOTE
• The communication option error (E. 1) is not included in the targets of Pr.500.
• Operations at communication error occurrences can be selected with Pr.502 Stop mode selection at communication
error. (Refer to page
640
9. APPENDIX
9.3 For customers using HMS network options
Description
Name
Normal
Communication error
(E.OP1)
Alarm signal(LF)
(Pr.502 = 3)
479)
Unit
- -
0.01 Hz signed
0.01 Hz unsigned
1 r/min signed
0.1% unsigned
- -
1 kWh unsigned
0.1/0.01 kWh unsigned
- -
Setting range
0 to 999.8 s
Normal
Error
Pr.500
setting time setting time
Type Read/write
-
R
R
R
R
-
R
R
-
Minimum setting Initial value
increments
0.1 s 0 s
Error
Recognition
Pr.500
ON