Mitsubishi Electric 800 Series Instruction Manual page 526

 BINARY VALUE
Object Object name
identifier
0 Inverter running
11 Inverter operation
ready
98 Alarm output
99 Fault output
200 Inverter running
reverse
300 Control input
instruction AU
301 Control input
instruction RT
302 Control input
instruction RL
303 Control input
instruction RM
304 Control input
instruction RH
305 Control input
instruction JOG
306 Control input
instruction MRS
307 Control input
instruction STOP
308 Control input
instruction RES
309 Control input
instruction CS
400 Run/Stop
401 Forward/Reverse
402 Fault reset
*1 R: Read only, W: Read/Write (Commandable values not supported), C: Read/Write (Commandable values supported)
Values written to the objects that support the commandable values are stored in the Priority Array, even when "Write Access Denied" is returned
due to inconsistency of the writing requirements such as the operating mode, on condition that the values are written within the setting range.
*2 The following signals cannot be controlled by the network: Jog operation, selection of automatic restart after instantaneous power failure, start
self-holding, and reset. Therefore control input instruction JOG, STOP, RES, and CS are invalid in the initial status. To use the control input
instruction JOG, STOP, RES, and CS, change the signals with Pr.185, Pr.186, Pr.188, Pr.189 (Input terminal function selection). (Refer to
page 343.) (Reset is available with ReinitializeDevice.)
*3 If communication operation command source is other than NET, the setting value can be written, but not to be applied.
Present value
*1
access type
R Represents inverter running (RUN signal) status.
R Represents inverter operation ready (RY signal) status.
R Represents alarm output (LF signal) status.
R Represents fault output (ALM signal) status.
R Represents inverter reverse running status.
C Controls the function assigned to terminal AU.
Setting 1 in this object turns ON the signal assigned to Pr.184 AU terminal
function selection.
C Controls the function assigned to terminal RT.
Setting 1 in this object turns ON the signal assigned to Pr.183 RT terminal
function selection.
C Controls the function assigned to terminal RL.
Setting 1 in this object turns ON the signal assigned to Pr.180 RL terminal
function selection.
C Controls the function assigned to terminal RM.
Setting 1 in this object turns ON the signal assigned to Pr.181 RM terminal
function selection.
C Controls the function assigned to terminal RH.
Setting 1 in this object turns ON the signal assigned to Pr.182 RH terminal
function selection.
C Controls the function assigned to terminal JOG.
*2 Setting 1 in this object turns ON the signal assigned to Pr.185 JOG terminal
function selection.
C Controls the function assigned to terminal MRS.
Setting 1 in this object turns ON the signal assigned to Pr.187 MRS terminal
function selection.
C Controls the function assigned to terminal STOP.
*2 Setting 1 in this object turns ON the signal assigned to Pr.188 STOP
terminal function selection.
C Controls the function assigned to terminal RES.
Setting 1 in this object turns ON the signal assigned to Pr.189 RES terminal
*2
function selection.
C Controls the function assigned to terminal CS.
Setting 1 in this object turns ON the signal assigned to Pr.186 CS terminal
*2
function selection.
C Controls the start/stop command. The start command is written after the
Speed scale is applied.
1: Start
0: Stop
C
Controls the forward/reverse rotation.
1: Reverse rotation
0: Forward rotation
C Clears fault output status.
(Release of an inverter fault without inverter reset is available.)
Description
*3
*3
5.12 (N) Operation via communication and its settings
3
4
5
5
5
6
7
8
9
10
525
5. PARAMETERS