Mitsubishi Electric 800 Series Instruction Manual page 281

 Monitor display for operation panel (Pr.52, Pr.774 to Pr.776)
• When Pr.52 = "0" (initial value), the monitoring of output frequency, output current, output voltage, 3-line monitor, and fault
display can be selected in sequence by pressing [NEXT].
• The Load meter, Motor excitation current and Motor load factor are displayed on the second monitor (output current)
position, among the monitors set in Pr.52. Other monitors are displayed in the third monitor (output voltage) position.
• Pr.774 sets the output frequency monitor, Pr.775 sets the output current monitor, and Pr.776 sets the monitor description
to be displayed at the output voltage monitor position. When Pr.774 to Pr.776 = "9999" (initial value), the Pr.52 setting
value is used.
NOTE
• For details on the operation panel, refer to the instruction manual of the operation panel (FR-LU08).
 Displaying the set frequency during stop (Pr.52)
• When Pr.52 = "100", the set frequency is displayed during stop, and output frequency is displayed during running. ("Hz" is
highlighted during stop.)
Pr.52 setting
0 During running/stop
100 During stop
Running
*1 Displays the frequency that is output when the start command is ON. The value considers the maximum/minimum frequency and frequency
jumps. It is different from the frequency setting displayed when Pr.52 = "5".
NOTE
• During an error, the output frequency at error occurrence appears.
• During output shutoff by the MRS signal, the values displayed are the same as during a stop.
• During offline auto tuning, the tuning state monitor takes priority.
280
5. PARAMETERS
5.8 (M) Monitor display and monitor output signal
Status Output frequency
Output frequency
Set frequency
Output frequency
Output current
Output current
*1
Output voltage Fault or alarm
indication
Output voltage Fault or alarm
indication