Mitsubishi Electric 800 Series Instruction Manual page 201

• When the remotely-set frequency is cleared by turning ON the RL (clear) signal after turning OFF (ON) both the RH and
RM signals, the inverter operates at the frequency in the remotely-set frequency cleared state if power is reapplied before
one minute has elapsed since turning OFF (ON) both the RH and RM signals.
CAUTION
• When using the remote setting function, set the maximum frequency again according to the machine.
Parameters referred to
Pr.1 Maximum frequency, Pr.18 High speed maximum frequency
Pr.7 Acceleration time, Pr.8 Deceleration time, Pr.44 Second acceleration/deceleration time, Pr.45 Second
page 190
deceleration time
Pr.28 Multi-speed input compensation selection
Pr.178 to Pr.182 (Input terminal function selection)
200
5. PARAMETERS
5.5 (F) Setting of acceleration/deceleration time and acceleration/deceleration pattern
Remotely-set frequency stored last time
Acceleration (RH)
Deceleration (RM) OFF
Clear (RL)
Forward rotation (STF)
Power supply
One minute
More than
one minute
Operation is performed at the set
frequency 0Hz.
ON
ON
ON
ON
page 253
page 226
page 343
Time
ON
ON