Mitsubishi Electric 800 Series Instruction Manual page 57

2.6.3 Wiring of control circuit
 Control circuit terminal layout
• Recommended cable gauge: 0.3 to 0.75 mm
AM 5 10E 10 SE SE
*1 This terminal operates as the terminal CA.
 Wiring method
 Power supply connection
Use crimp terminals and stripped wire for the control circuit wiring. For single wire, the stripped wire can be used without crimp
terminal.
Connect the end of wires (crimp terminal or stranded wire) to the terminal block.
1.
Strip the signal wires as shown below. If too much of the wire is stripped, a short circuit may occur with neighboring
wires. If not enough of the wire is stripped, wires may become loose and fall out. Twist the stripped end of wires to
prevent them from fraying. Do not solder it.
2.
Use appropriate crimp terminals (ferrules, blade terminals, etc.). Insert wires to the crimp terminal, and check that
the wires come out for about 0 to 0.5 mm from a sleeve. Check the condition of the crimp terminals after crimping.
Do not use the crimp terminals of which the crimping is inappropriate, or the face is damaged.
• Crimp terminals commercially available (as of October 2020)
Phoenix Contact Co., Ltd.
2
Wire gauge (mm )
0.3
0.5
0.75
1
1.25, 1.5
0.75 (for two wires)
*1 A ferrule terminal with an insulation sleeve compatible with the MTW wire which has a thick wire insulation.
*2 Applicable to the terminals A1, B1, C1, A2, B2, and C2.
56
2. INSTALLATION AND WIRING
2.6 Control circuit
∗1
2 5 4 1 F/C +24 SD So SOC
RUN SU IPF OL FU
Wire strip length
10 mm
With insulation sleeve
AI 0,34-10TQ —
AI 0,5-10WH —
AI 0,75-10GY A 0,75-10
AI 1-10RD A 1-10
AI 1,5-10BK A 1,5-10
AI-TWIN 2  0,75-10GY
—
2
SD SIC S1 S2 PC A1
PC RL RM RH RT AU
Damaged
Ferrule part No.
Without insulation sleeve
B1 C1 A2 B2 C2
STP MRS RES SD SD STF STR JOG
Wires are not inserted
Crumpled tip into the sleeve
*1
For UL wire
— CRIMPFOX 6
AI 0,5-10WH-GB
AI 0,75-10GY-GB
AI 1-10RD/1000GB
*2
AI 1,5-10BK/1000GB
—
CS
Unstranded
wires
Crimping tool
model No.