Operation
Feedback During Normal Operation
During normal operation, if Zone Numbers and/or Master Control Numbers are assigned to system devices, alpha
and numeric feedback will flash on the display of the RS232 Interface when an action occurs. The following chart
is used to identify feedback.
Display
"
"
Alternately flashing "
" followed by a Control
Number, and "
" followed by a Button Number.
Alternately flashing " " followed by a Zone Number.
Flashing "
"
Flashing "
"
Alternately flashing "
", "
Select LED fluttering
Assignment Mode
Up
RX
Down
Select
Level Set Mode
Power
For questions regarding the feedback via
?
RS232, see the RadioRA
Programming Guide (P/N 044-006).
"
RS232 Protocol and
®
RadioRA
®
Cause
A valid RS232 command was received.
A numbered Master Control button was pressed and
feedback was transmitted via the RS232 Interface.
Example: Display shows "
means that button 16 (ALL ON) was pressed on
Master Control 02.
The status of a numbered zone was changed locally
and feedback was transmitted via the RS232
Interface. Example: Display shows " ", "24" means
that the status of zone 24 was changed locally.
The RS232 Interface caused the RadioRA
to go into Security Solid Mode.
The RS232 Interface caused the RadioRA
to go into Security Flash Mode.
The RS232 Interface caused the RadioRA
to go into Security Solid and Security Flash Mode.
The RS232 Interface is transmitting an RF
command.
Setup Guide Addendum for the RS232 Interface
", "02", "
", "I 6"
System
®
System
®
System
®
43