Table of Contents
Advertisement
Advanced Programming
Assigning Master Control Numbers
Master Control Numbers are only necessary if: the RS232 Interface will be used to control the LEDs on a Master
Control, RS232 feedback is desired when a Master Control button or a Raise/Lower button is pressed, or RS232
feedback is desired when a Cordless Master Control wakes up or goes to sleep. For a description of a Master
Control Number, See Definitions of Common Terms on page 7.
Step 1
Complete the Master Control
Number Worksheet
Complete the Master Control Number
Worksheet on page 47 for easy reference
while assigning the Master Control Numbers.
1
Master Bedroom
2
Foyer
3
Security closet
Main hallway
4
5
6
7
8
9
10
11
12
Step 2
15 button Tabletop
10 button Cordless
Switch Closure Interface
• Continued on next page.
RadioRA
Setup Guide Addendum for the RS232 Interface
®
Begin assigning Master
Control Numbers
Simultaneously press and hold the Up and
Down buttons until the Select LED turns ON
and U I appears on the display (approximately
3 seconds).
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
(800) 523-9466
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Assignment Mode
Up
TX
RX
Down
Select
Level Set Mode
Power
After 3 seconds the display will begin to
alternately flash a Phantom Button Number
and U I.
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
(800) 523-9466
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Assignment Mode
Up
TX
RX
Down
Select
Level Set Mode
Power
29
Advertisement
Table of Contents
