Lutron Electronics RadioRA RA-RS232 Setup And Installation Manual page 28

Advanced Programming
Step 5
Complete Zone Number
assignment
Simultaneously press and hold the Up and
Down buttons until all the LEDs begin to flutter
(approximately 3 seconds).
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select
Display will stop flashing and the Select LED
will turn OFF.
Zone Numbers must be assigned to each
RS232 Interface in the system for which zone
feedback is desired via RS232.
• Repeat Steps 1 through 5 to assign Zone
Numbers to any remaining RS232
Interfaces.
28 RadioRA Setup Guide Addendum for the RS232 Interface
®
(800) 523-9466
Assignment Mode
Level Set Mode Power
To verify a Zone Number assignment, change
?
the status of the Dimmer, Switch or GRAFIK
Eye Control Unit by turning it ON or OFF.
Dimmer
The Display will flash
Number assigned. This sequence will flash
two times.
and o erating instructions.
Level Set LED – OFF
(800) 523-9466
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Assignment Mode
Up
TX RX
Down Select Level Set Mode
Switch
OR
GRAFIK Eye
Control Unit
TRON
followed by the Zone
Power