Lutron Electronics RadioRA RA-RS232 Setup And Installation Manual page 27

Advanced Programming
Step 3
Select a Zone Number to
program
Press and hold the Up or Down button to
select the Zone Number you want to program.
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select
Display will alternately flash the selected Zone
Number and U 2.
and o erating instructions.
Level Set LED – OFF
(800) 523-9466
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select Level Set Mode
(800) 523-9466
Assignment Mode
Level Set Mode Power
Assignment Mode
Power
RadioRA
Step 4
Assign a Dimmer, Switch or
GRAFIK Eye Control Unit to a
Zone Number
Assign a Dimmer or Switch to the displayed
Zone Number by turning the Dimmer or Switch
ON or OFF.
OR
Assign a GRAFIK Eye Control Unit to the
displayed Zone Number by changing scene of
the GRAFIK Eye Control Unit.
LUTRON
The Assign LED will flash for approximately 2
seconds. The Level LED will then turn ON
indicating that the Zone Number is now
programmed.
If you assign a Dimmer, Switch or GRAFIK Eye
Control Unit to the wrong Zone Number, simply
assign the Dimmer, Switch or GRAFIK Eye
Control Unit to the correct Zone Number. The
programming for the old Zone Number will be
erased.
• Repeat Steps 3 and 4 for any remaining
Zone Numbers you wish to assign.
• Continued on next page.
Setup Guide Addendum for the RS232 Interface
®
OR
27