Lutron Electronics RadioRA RA-RS232 Setup And Installation Manual page 9

Adding an RS232 Interface
Step 3
Complete RS232 Interface
activation
Press and hold the ACTIVATE CONTROLS
button on any Repeater until the green
ACTIVATE CONTROLS LED turns OFF
(approximately 3 seconds).
REPEATER ACTIVATE
MAIN REPEATER
AUXILIARY CONTROLS
The green ACTIVATE CONTROLS LED on
ALL Repeaters will turn OFF. The MAIN or
AUXILIARY LED will remain on.
REPEATER ACTIVATE
MAIN REPEATER
AUXILIARY CONTROLS
• The RS232 Interface is now activated.
VERIFY
BEEP
FLASH
VERIFY
BEEP
FLASH
RadioRA
®
If you want to verify that your RS232 Interface
?
has been activated, enter Flash Mode on any
Repeater (see RadioRA Setup Guide's
Troubleshooting Section).
The RS232 Interface's Display and LEDs will
begin to flash.
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select
Exit Flash Mode on the Repeater. The RS232
Interface's Display and LEDs will stop flashing.
• Proceed to the RS232 Programming
Worksheet on page 10.
Setup Guide Addendum for the RS232 Interface
(800) 523-9466
Assignment Mode
Level Set Mode Power
9