Lutron Electronics RadioRA RA-RS232 Setup And Installation Manual page 18

Phantom ROOM Button Programming
Step 3
Set light levels for Dimmers
Use the dimming rocker to adjust the light
level of any Dimmer(s) assigned to that button.
This is the light level that the Dimmers will turn
ON to when the ROOM button is pressed ON.
While setting light levels
• Dimmers assigned to a Phantom ROOM
Button cannot be turned OFF.
• Dimmers not assigned to a Phantom ROOM
Button cannot be turned ON.
18 RadioRA Setup Guide Addendum for the RS232 Interface
®
Step 4
Select a GRAFIK Eye
At the GRAFIK Eye Control Unit, select one of
the pre-programmed scenes (1 through 4) by
turning that scene ON.
LUTRON
The GRAFIK Eye Control Unit will turn ON to
the scene selected in this step when the
Phantom ROOM Button is turned ON. The last
scene selected on the GRAFIK Eye Control
Unit will be the scene programmed to the
Phantom ROOM Button.
While setting light levels
• GRAFIK Eye Control Units assigned to a
Phantom ROOM Button cannot be turned
OFF.
• GRAFIK Eye Control Units not assigned to a
Phantom ROOM Button cannot be turned ON.
scene
®