Lutron Electronics RadioRA RA-RS232 Setup And Installation Manual page 15

Phantom ROOM Button Programming
Step 3
Assign a Dimmer, Switch or
GRAFIK Eye Control Unit
Control to the Phantom Button
Notes:
• Multiple Dimmers, Switches or GRAFIK Eye Control
Units can be assigned to a single Phantom ROOM
Button.
• Controls must be assigned to a Phantom Button
while its number is flashing on the display.
Assign Dimmers or Switches to the Phantom
Button by turning the Controls ON.
Assign a GRAFIK Eye Control Unit to the
Phantom Button by changing the selected
GRAFIK Eye scene.
Dimmer
Note: GRAFIK Eye Control Units will automatically
turn on to scene 1 once assigned.
If you assign the wrong Dimmer,
Switch or GRAFIK Eye Control Unit to
a Phantom Button, turn the Dimmer,
Switch or GRAFIK Eye Control Unit
OFF to unassign it.
Switch
OR
GRAFIK Eye
Control Unit
TRON
RadioRA
®
Step 4
Select next Phantom ROOM
Button to program
To assign Dimmers, Switches or GRAFIK Eye
Control Units to another Phantom ROOM
Button, press and hold the Up or Down button
to select the next Phantom ROOM Button you
want to program.
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select
Assign LED will be ON. Selected Phantom
ROOM Button Number will flash on the
display.
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select
Perform Step 3 for this newly-selected
Phantom ROOM Button.
• Proceed to Step 5 when all Phantom
ROOM Buttons on the RS232 Interface
have been programmed.
• Continued on next page.
Setup Guide Addendum for the RS232 Interface
(800) 523-9466
Assignment Mode
Level Set Mode Power
(800) 523-9466
Assignment Mode
Level Set Mode Power
15