Lutron Electronics RadioRA RA-RS232 Setup And Installation Manual page 22

Phantom SCENE Button Programming
Step 5
Complete assigning Dimmers,
Switches or GRAFIK Eye
Control Units to Phantom
SCENE Buttons
Press and hold the Assign button until all the
LEDs begin to flutter (approximately 3
seconds).
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select
Display will be ON and the Assign LED will be
OFF.
• Proceed to Setting Light Levels/GRAFIK
Eye SCENE Selection for Phantom
SCENE Buttons on page 23.
22 RadioRA Setup Guide Addendum for the RS232 Interface
®
(800) 523-9466
Assignment Mode
Level Set Mode Power