Lutron Electronics RadioRA RA-RS232 Setup And Installation Manual page 2

Notes on this Manual
This manual is an addendum to the original RadioRA
Interface are contained in this manual. For more information on programming the remainder of your RadioRA
System, or for advanced features, refer to the original RadioRA
Important Application Notes
1. The RS232 Interface is a type of Master Control. The System can have a maximum of 12 Master Controls.
Therefore, for every 1 Master Control NOT used, 1 RS232 Interface may be used in its place.
2. ALL ON is Phantom Button 16 and ALL OFF is Phantom Button 17.
Consumer Information
This symbol is intended to alert the user to the presence of important installation and operating instructions.
Danger
This RadioRA system must not be used to control equipment, other than lighting, which is not visible from every master or
®
local control location. It also must not be used to control equipment which could create hazardous situations such as
entrapment if operated accidentally. Examples of equipment which must not be controlled by this RadioRA
(but are not limited to) motorized gates, garage doors, industrial doors, and microwave ovens, heating pads, etc. It is the
installer's responsibility to ensure that the equipment, other than lighting, being controlled is visible from every master or
local control location and that only suitable equipment is connected to this RadioRA
FCC Information
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by Lutron Electronics Co. could void the user's authority to operate this equipment.
2 RadioRA Setup Guide Addendum for the RS232 Interface
®
Setup Guide. The procedures to setup a RadioRA
®
Setup Guide (P/N 044-001).
®
®
system include
®
system.
RS232
®
®