Lutron Electronics RadioRA RA-RS232 Setup And Installation Manual page 39

Advanced Programming
Step 3
Select the Phantom Button
you want to copy from the
RS232 Interface
On a previously programmed RS232 Interface,
press and hold the Up or Down button until the
Phantom Button Number you want to copy is
on the display.
(800) 523-9466
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Assignment Mode
Up
TX RX
Down Select Level Set Mode Power
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline: (800) 523-9466
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Assignment Mode
Up
TX RX
Down Select Level Set Mode Power
Press and hold the Select button until the
display turns OFF (approximately 3 seconds).
and o erating instructions.
Level Set LED – OFF
(800) 523-9466
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Assignment Mode
Up
TX RX
Down Select Level Set Mode Power
Previously Programmed
RS232 Interface
• Repeat Steps 2 and 3 for all Master
Control buttons for which you want to
copy programming.
When the display turns
OFF for a few seconds and
then resumes flashing
programming has been
copied to
Newly Programmed
Master Control
RadioRA
®
Step 4
Complete copy button
programming
Simultaneously press and hold the 1st and 5th
buttons in the right most column until all LEDs
begin to flutter (approximately 3 seconds).
Newly Programmed
Master Control
• Repeat Steps 1 through 4 to copy
button programming on any remaining
unprogrammed Master Controls.
Setup Guide Addendum for the RS232 Interface 39