Table of Contents
Advertisement
Programming Preparations
Step 3
Changing ROOM/SCENE
assignment
Press and release the Assign button to make
the Phantom Button Number on the display a
ROOM; the Assign LED will turn ON. Press
and release the Level button to make the
Phantom Button Number on the display a
SCENE; the Level LED will turn ON.
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX
RX
Down
Select
Display will alternately flash the selected
Phantom Button Number and U I.
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX
RX
Down
Select
• Repeat Steps 2 and 3 to change ROOM/
SCENE assignment for any remaining
buttons.
(800) 523-9466
ROOM
Assignment Mode
SCENE
Level Set Mode
Power
(800) 523-9466
ROOM
Assignment Mode
SCENE
Level Set Mode
Power
RadioRA
Step 4
Completing ROOM/SCENE
assignment
Simultaneously press and hold the Up and
Down buttons until all the LEDs begin to flutter
(approximately 3 seconds).
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX
RX
Down
Select
Display will stop flashing. The Select LED and
corresponding ROOM/SCENE LEDs will turn
OFF.
• Proceed to Assigning Dimmers,
Switches or GRAFIK Eye Control units to
Phantom ROOM Buttons on page 14.
Setup Guide Addendum for the RS232 Interface
®
(800) 523-9466
Assignment Mode
Level Set Mode
Power
13
Advertisement
Table of Contents
