Adding An Rs232 Interface; Activating An Rs232 Interface - Lutron Electronics RadioRA RA-RS232 Setup And Installation Manual

Adding an RS232 Interface

Activating an RS232 Interface

The RS232 Interface is a type of Master Control. The RadioRA System can have a maximum of 12 Master
Controls. Therefore, for every 1 Master Control NOT used, 1 RS232 Interface may be used in its place.
Step 1
Begin RS232 Interface
activation
Press and hold the ACTIVATE CONTROLS
button on any Repeater until the green
ACTIVATE CONTROLS LED turns ON
(approximately 3 seconds).
REPEATER ACTIVATE
MAIN REPEATER
AUXILIARY CONTROLS
The green ACTIVATE CONTROLS LED on
ALL Repeaters will turn ON.
REPEATER ACTIVATE
MAIN REPEATER
AUXILIARY CONTROLS
8 RadioRA Setup Guide Addendum for the RS232 Interface
®
VERIFY
BEEP
FLASH
VERIFY
BEEP
FLASH
Step 2
Activate RS232 Interface
Note: Press any button to restore the display if
it is OFF.
Press any button.
• All LEDs will flutter, then
• Top and bottom row of the display will flash
alternately.
and o erating instructions.
Level Set LED – OFF
(800) 523-9466
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Assignment Mode
Up
TX RX
Down Select Level Set Mode
Display will flash 0 I when the RS232 Interface
has been activated.
and o erating instructions.
Level Set LED – OFF
(800) 523-9466
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Assignment Mode
Up
TX RX
Down Select Level Set Mode
If an RS232 Interface fails to respond as
?
described above, consult the Troubleshooting
Section on page 44.
Power
Power