Lutron Electronics RadioRA RA-RS232 Setup And Installation Manual page 24

Phantom SCENE Button Programming
Step 3
Set light levels/select GRAFIK
Eye scenes
Go to any assigned Dimmer (which will be
ON at 50%). Adjust this Dimmer's
programmed light level for the selected
Phantom SCENE Button using the dimming
rocker, or turn the Dimmer OFF if it is to be
turned OFF when this Phantom SCENE
Button is selected.
Adjust light levels
Go to any assigned Switch (which will be
ON). Turn the Switch OFF if it is to be turned
OFF when this Phantom SCENE Button is
selected.
Go to any assigned GRAFIK Eye Control Unit
(which will be ON at scene 1). Select from pre-
programmed scenes (1 through 4) by turning
that scene ON or select OFF if it is to be
turned OFF when this Phantom SCENE
Button is selected.
LUTRON
24 RadioRA Setup Guide Addendum for the RS232 Interface
®
OR
Turn OFF
Step 4
Select next Phantom SCENE
Button to program
To set the light levels for another Phantom
SCENE Button, press and hold the Up or
Down button to select the Phantom SCENE
Button you want to program.
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select
Level Set LED will be ON. Current Phantom
SCENE Button Number will flash on the
display.
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select
Perform Step 3 for this newly-selected
Phantom SCENE Button.
• Proceed to Step 5 when all Phantom
SCENE Buttons on the RS232 Interface
have been programmed.
(800) 523-9466
Assignment Mode
Level Set Mode Power
(800) 523-9466
Assignment Mode
Level Set Mode Power