Programming Preparations; Rs232 Programming Worksheet - Lutron Electronics RadioRA RA-RS232 Setup And Installation Manual

Programming Preparations

RS232 Programming Worksheet

After the RS232 Interface has been activated, it can be programmed so that a light or a group of lights can be
controlled by one or more Phantom Buttons. Prior to programming your system, complete the RS232
Programming Worksheet (page 11).
Step 1
Record all Dimmer, Switch,
and GRAFIK Eye Control Unit
locations and control types
along the top of the worksheet
(Accessory Dimmers and Accessory Switches do not
need to be recorded.)
RS232 Interface
M.C.Type:
M.C. Location:
1
2
3
4
Step 2
Select an RS232 Interface
Start with any RS232 Interface and write down its
location.
RS232 Interface
M.C.Type:
A/V Room
M.C. Location:
1
2
3
4
10 RadioRA Setup Guide Addendum for the RS232 Interface
®
Step 3
Write a description for each Phantom Button under the
Description column of the worksheet.
1 2 3 4 5
Step 4
Select which Dimmers, Switches or GRAFIK Eye
Control Units will be controlled by each Phantom
Button by going across the worksheet and placing a
1 2 3 4 5
check in the corresponding box(es).
• Repeat Steps 1 through 4, for all RS232
Interfaces in your system.
• Proceed to Assigning a Phantom Button
as a ROOM or SCENE on page 12.
Record Phantom Button
names
RS232 Interface
M.C.Type:
A/V Room
M.C. Location:
1 M. Bedroom / Room
2 Hall / Room
Movie / S
3
4
Select Dimmers, Switches or
GRAFIK Eye Control Units
RS232 Interface
M.C.Type:
A/V Room
M.C. Location:
1 M. Bedroom / Room
Hall / Room
2
3 Movie / Scene
Goodnight / Scene
4
1 2 3 4 5
1 2 3 4 5