Copying Button Programming From An Rs232 Interface To A Master Control - Lutron Electronics RadioRA RA-RS232 Setup And Installation Manual

Advanced Programming
Copying Button Programming from an RS232 Interface to
a Master Control
If you have a Master Control in your system, you can copy the Phantom Button programming from a previously
programmed RS232 Interface to an un-programmed Master Control button so that both buttons function identically.
Step 1
Begin copying button
programming
On the Master Control you want to program,
simultaneously press and hold the 1st and 5th
buttons in the right most column until the
upper right LED begins to blink (approximately
3 seconds).
Table Top Master
Un-programmed
Master Control
Un-programmed
Master Control
Note: LEDs on all other Master Controls and
RS232 Interfaces will flash.
38 RadioRA Setup Guide Addendum for the RS232 Interface
®
OR
Wall Master
ALL ON
ALL OFF
Upper right LED blinks.
Step 2
Select the button you want to
program
Press and release the button you want to
program. Its LED will begin to blink.
Un-programmed
Master Control
Un-programmed
Master Control
The programming from a SCENE button cannot
be copied to a ROOM button, or vice versa.
LED blinks.