Lutron Electronics RadioRA RA-RS232 Setup And Installation Manual page 34

Advanced Programming
Step 3
Changing hardware
handshaking settings
Press and release the Assign button to turn
hardware handshaking ON; the Assign LED
will turn ON. Press and release the Level
button to turn hardware handshaking OFF, the
Level LED will turn ON.
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select
Display will alternately flash 0 I and U 4.
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select
34 RadioRA Setup Guide Addendum for the RS232 Interface
®
(800) 523-9466
ON
Assignment Mode
OFF
Level Set Mode Power
(800) 523-9466
ON
Assignment Mode
OFF
Level Set Mode Power
Step 4
Completing hardware
handshaking assignment
Simultaneously press and hold the Up and
Down buttons until all the LEDs begin to flutter
(approximately 3 seconds).
and o erating instructions.
Level Set LED – OFF
(800) 523-9466
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Assignment Mode
Up
TX RX
Down Select Level Set Mode
Display will stop flashing and the Select LED
will turn OFF.
Power