Returning To Default Factory Settings Rs232 Interface - Lutron Electronics RadioRA RA-RS232 Setup And Installation Manual

Returning to Default Factory Settings
RS232 Interface
Returning an RS232 Interface to Default Factory Settings will permanently delete all current programming
information. Do not do this unless you are sure that it is necessary. For more information call the
Lutron Technical Support Center at 1-800-523-9466.
Step 1
Begin returning to Default
Factory Settings
Ensure that the ACTIVATE REPEATER LED or
ACTIVATE CONTROLS LED on any Repeater
is NOT ON before proceeding. If either LED is
ON, press the corresponding button until its
LED turns OFF (approximately 3 seconds).
Press and hold the Up and Assign buttons
until the display turns OFF and the LEDs
begin to flutter (approximately 3 seconds).
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select
46 RadioRA Setup Guide Addendum for the RS232 Interface
®
(800) 523-9466
Assignment Mode
Level Set Mode Power
(800) 523-9466
Assignment Mode
Level Set Mode Power
Step 2
Complete returning to Default
Factory Settings
While the LEDs are fluttering, press and hold
the Down and Level Set buttons until the
RS232 Interface resets ("– –" will be on the
display).
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline: (800) 523-9466
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select Level Set Mode
All LEDs (except the Power LED) will turn OFF
and the display will show "– –" indicating that
the RS232 Interface has been returned to
Default Factory Settings.
and o erating instructions.
Level Set LED – OFF
(800) 523-9466
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Assignment Mode
Up
TX RX
Down Select Level Set Mode
Assignment Mode
Power
Power