Lutron Electronics RadioRA RA-RS232 Setup And Installation Manual page 19

Phantom ROOM Button Programming
Step 5
Select next Phantom ROOM
Button to program
To set the light levels for another Phantom
ROOM Button, press and hold the Up or Down
button to select the Phantom ROOM Button
you want to program.
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select
Level Set LED will be ON. Selected Phantom
ROOM Button Number will flash on the display.
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select
Perform Step 3 for this newly-selected
Phantom ROOM Button.
• Proceed to Step 6 when all Phantom
ROOM Buttons on the RS232 Interface
have been programmed.
(800) 523-9466
Assignment Mode
Level Set Mode Power
(800) 523-9466
Assignment Mode
Level Set Mode Power
RadioRA
Step 6
Complete setting light levels/
GRAFIK Eye scene selection
Press and hold the Level Set button until all
the LEDs begin to flutter (approximately 3
seconds).
and o erating instructions.
Level Set LED – OFF
For additional assistance call the Lutron Hotline:
RadioRA is a trademark of Lutron Electronics Co. Inc.
This product may be covered by one or more of the following
U.S. patents: 5,248,919; 5,399,940; 5,736,965; 5,798,581;
5,838,226; 5,848,054; 5,905,442, 5,982,103
Up
TX RX
Down Select
Level Set LED will turn OFF and the display
will stop flashing.
Note: To access scenes 5-16 on a GRAFIK
?
Eye Control Unit, refer to Application Note #48
(P/N 366-730).
Setup Guide Addendum for the RS232 Interface
®
(800) 523-9466
Assignment Mode
Level Set Mode Power
19