Table of Contents
Advertisement
4.4.4 Security
Note. User 1 is the System Administrator and is able to change the Security type and all other security parameters. Other
users can change only the 'Setup level security' setting and only if 'Security system' is set to 'Basic'.
Set the Security type.
Select Basic or Advanced security – see Section 4.1.1.
Set the method of access to the Configuration level.
If 'Password protected' is selected, access is by means of
the password set for the user in Section 4.4.5.
Notes.
• If 'Switch protected' is selected, access to the
Configuration level for all users is prohibited once the
changes have been saved and made active. Access to the
Configuration level is then achieved only by setting the
internal security switch to the 'Configuration Level Not
Protected' position – see Fig. 4.2, page 46.
• Configuration level security is accessed and modified only
by the System Administrator (User 1).
When set to 'On', access to the Setup level is password
protected.
• If 'Security system' is set to 'Basic', access to the Setup
level is protected by a single password for all users.
• If 'Security system' is set to 'Advanced', access to the
Setup level is protected by each user's unique password.
Note. Displayed only if 'Security system' is set to 'Basic'
and 'Setup level security' is set to 'On' – see above.
Enter the password to be used by all users to access the
Setup level.
4 CONFIGURATION...
55
Advertisement
Table of Contents
