Recording Channel Setup - ABB InformIT SM2000 User Manual

...4 CONFIGURATION

4.6.1 Recording Channel Setup

Note. Parameters applying only to Advanced configuration are identified
A – No Source
B – Analog Source
C – Digital Source
•1 If this parameter is changed from any previous setting other than 'None', a new internal data file for this recording channel is
created. All historical data stored internally for this channel is lost. If this parameter is changed from a previous setting of 'None',
new internal data files for all enabled recording channels are created. Any unarchived data is lost.
72
A
.
Select the signal source for the selected channel. This can be
•1
any external analog or digital signal. See APPENDIX 1 for full
list.
Notes.
• The tabs change according to the selection made:
•1
• Setting a channel source to 'None' does
analog input to which the channel was previously assigned
– i.e. the analog input continues to be monitored. To
switch off an analog input, set 'Analog I/P Type' for the
required channel to 'Off' – see Section 4.6.2.
•1
Note. The trace
'Configuration type' is set to 'Basic' (see Section 4.4.1). The
trace colors are fixed as:
st nd
1 2
Magenta Red
Each recording channel can be configured to position its
trace in a specific zone in the chart views in order to separate
traces that would otherwise be very close to each other.
Trace Color
Select the color used to display the trace and its short tag on
A
Chart and Digital Indicator views. Trace colors can be
selected from the following:
Cyan, Magenta, Blue, Dark Cyan, Dark Blue, Yellow, Light
Green, Dark Yellow, Green, Red, Brown, Black
Zone
Select one of the 15 pre-defined zones available.
switch off the
not
color cannot be changed
rd th th
3 4 5
Black Green Blue
when
th
6
Brown