Table of Contents
Advertisement
TRANSPORT
lifting and lowering the machine with hydraulic jacks
26
Lifting and lowering the machine with hydraulic jacks
........ when transporting with rollers
Use only transport rollers with a total minimum load capacity of 23 t.
This ensures that the plate support of the steering gear fits into the
mounting provided in the machine bed (Ø 240 mm) for this purpose.
The figure below shows the locations where the hydraulic jacks (X) and transport
rollers (Y) must be positioned on the machine frame.
Steel plates are cast in at the described points to reinforce the machine bed.
Procedure:
Lifting
– This procedure applies in principle also to lowering the machine
after the transport using rollers – only in reverse order.
– It is essential to connect and secure both fixed transport
rollers with a bar (b).
• Attach hydraulic jacks (X) and raise the machine. (Fig.: Locations for hydraulic
jacks and transport rollers)
• Place suitable timber underneath and secure.
• Release the clamp on the bar (b) and push the transport rollers together.
DIE235ZZ_06.tif
X
Fig.
Locations for hydraulic jacks and transport rollers
Y
b
Transport, Installation, Commissioning
G300.2 G320.2 (turning length 1400 mm) zero series
DIE235EN - 2022-12-05
X
Advertisement
Table of Contents
