Table of Contents
Advertisement
INSTAllATION
Installing the machine
DIE002ZZ_04.tif
Fig.: Hydraulic jacks
Adjusting screws (1) of
the wedge shoes
(B + C) point outwards
Fig.:
"Leveling the entire machine"
40
Installing the machine
The machine G300.2/G320.2 is equipped with five adjustable feet as standard (see
Fig.: "Adjustable machine foot" and "Leveling the entire machine"). However, only
the machine feet A, B, and C (wedge shoes) are used here to level the machine.
To enable the installation of a bar feeder, the machine must be ad-
justed to 1400 mm +/- the main spindle height. Note the adjustment
range of the wedge shoes +/- 10 mm
Be sure to follow the procedure described below.
Before finally setting the machine down at the installation site, turn
1976
back the machine feet D, E as far as necessary so that they have no
influence on the alignment of the machine. Also, rotate the wedge
shoes B and C so that the set screws (1) point outwards.
1350
980
Fig.:
Adjustable machine foot (wedge shoes)
383
A, B, C
0
1
1350
R1701.10031_25.eps
2237
2200
D
810
B
1
0
615
1105
DIE235ZZ_15.eps
Fig.:
Adjustable machine foot
D, E
M
X
A
X
M
740
Transport, Installation, Commissioning
G300.2 G320.2 (turning length 1400 mm) zero series
L1901.10011_02.eps
E
C
1
DIE235EN - 2022-12-05
Advertisement
Table of Contents
