Table of Contents
Advertisement
INSTAllATION
Installation and leveling of the chip conveyor
Y
Fig. b
DIE012ZZ_51.tif
Transport, Installation, Commissioning
G300.2 G320.2 (turning length 1400 mm) zero series
DIE235EN - 2022-12-05
Installation and leveling of the chip conveyor
Observe the following when installing the chip conveyor in the machine: After push-
ing the chip conveyor into the machine, ensure that it is raised high enough – using
the adjusting screws (X) – so that the chip conveyor's circumferential sealing lip (Y')
is positioned on the contact surface (Y) below the machine and therefore provides
a seal (Figs. a and b).
Before removing the chip conveyor from the machine, be sure to
lower it back onto the rollers again using the adjusting screws (X).
Pay attention to sealing lips (Y')!
Due to the different chip conveyors that can be installed on the
machines, the respective manufacturer's documentation must be
observed during installation.
Fig.: a
X
Y'
DIE134ZZ_25.tif
X
DIE134ZZ_26.tif
X
X
DIE134ZZ_27.tif
X
DIE134ZZ_32.tif
X
X
DIE134ZZ_31.tif
X
X
X
45
Advertisement
Table of Contents
