Table of Contents
Advertisement
AM025
- Check hydraulic and lubrication systems
Orientation
10
Carrying out the maintenance activities described below requires
special knowledge. For this reason, these maintenance activities
must only be carried out by staff that has received adequate training
by the machine manufacturer!
Operating fluids such as hydraulic fluids, cooling lubricants, lubricating greases/oils
are also subject to degradation or aging as the components involved in this process,
and must therefore be serviced, refilled or replaced at regular intervals. Do not use
cotton waste and highly volatile solvents such as petroleum spirit, trichloroethylene
or similar cleaning agents. The machine must not be cleaned with compressed air.
To ensure trouble-free operation, periodic checks of the oil level are necessary. The
fill level must be between the upper and lower marks on the oil sight glass.
During maintenance of the lubrication system, first perform a visual inspection of all
components involved in lubrication for leaks and their visual condition. The following
components must be examined during maintenance of the lubricating oil system:
-
Pressure gauges
-
Metering valves
-
Pressure sensors
-
Fluid lines belonging to the lubricating oil supply
For all work in connection with operating materials, the information in
the data sheets of the respective manufacturers and the information
in the document Notes on Operating Materials must be observed.
Screws on the hydraulic system, the connected components, and the
supply lines must be tightened to the manufacturer's specified
torques.
Maintenance Summary - Care activities
Maintenance Instructions
DIM123EN - 26.04.2022
MS24-6
Advertisement
Table of Contents
