Boss-N1 Module Kit - Dell PowerEdge R760 Installation And Service Manual

BOSS-N1 module kit

The BOSS-N1 module supports up to two M.2 NVMe SSDs.
Before you begin the installation or removal process, follow the
instructions.
Table 152. BOSS-N1 module kit components
Components in kit
BOSS-N1 controller card module
BOSS-N1 card carrier
M.2 NVMe SSD
M.2 NVMe SSD capacity label
BOSS-N1 card carrier blank
M3 x 0.5 x 4.5 mm screws
BOSS-N1 power cable for Riser 1 (220 mm)
BOSS-N1 signal cable for Riser 1 (170 mm)
BOSS-N1 power cable for x4 rear drive module (260 mm)
BOSS-N1 signal cable for x4 rear drive module (240 mm)
NOTE: *The quantity depends on the purchase order.
†
NOTE: The quantity depends on the BOSS-N1 card carrier
To remove the BOSS blank :
1. Power off the system and
2. Use a screwdriver to push out the blank from the BOSS-N1 module bay.
Figure 257. Removing the BOSS-N1 module blank
remove the system cover.
safety guidelines and before working inside the system
R760 (quantity)
1
1 or 2*
1 or 2*
†
1 or 2
1
1
1
1
1
1
Upgrade Kits 307