Removing The Adapter Perc Module - Dell PowerEdge R760 Installation And Service Manual

Figure 128. Installing the rear mounting front PERC module
Next steps
1. Connect all the cables, observe the cable routing.
2. Install the cooling fan cage
3. If removed, install the air shroud
4. Install the drive backplane
5. Follow the procedure listed in

Removing the adapter PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If required, remove the air shroud
4. If required, remove the drive backplane
5. Remove the cooling fan cage
6. Remove the expansion card
7. Disconnect all the cables from the adapter PERC (APERC) card, observe the cable routing.
NOTE: Refer to cable routing
NOTE: APERC module must be installed only in expansion card riser 1 or riser 2.
Steps
1. Tilt the expansion card retention latch lock to open.
2. Pull the card holder before removing the card from the riser.
3. Hold the APERC module by the edges. and pull the module from the expansion card connector on the riser.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
174 Installing and removing system components
assembly.
or install the GPU air
cover.
After working inside your
Safety instructions.
Before working inside your
or remove the GPU air
cover.
assembly.
riser.
section for more information.
shroud.
system.
system.
shroud.