Removing R1 And R4 Paddle Cards - Dell PowerEdge R760 Installation And Service Manual

NOTE: The GPU air shroud filler must be installed, if single-width GPU card or empty riser is used.
2. Install the full length expansion card
3. Install the GPU air shroud top
4. Follow the procedure listed in
5. Install any device drivers required for the card as described in the documentation for the card.

Removing R1 and R4 paddle cards

R1 and R4 paddle cards are supported on 24 x 2.5-inch NVMe Gen4 (passive) configuration only.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud
4. Remove the cooling fan cage
NOTE: Observe the cable routing before disconnecting the cables.
5. Remove the paddle card cable from side wall bracket.
6. Disconnect the paddle card cables from the drive backplane.
Steps
Press the blue release tab on the paddle cards and holding the edges lift the paddle cards from the riser connector on the
system board.
Figure 206. Removing the R1 paddle card
riser.
cover.
After working inside your
Safety instructions.
Before working inside your
or remove the GPU air shroud.
assembly.
system.
system.
Installing and removing system components 263