Idrac Quick Sync 2 Indicator Codes; Idrac Direct Led Indicator Codes - Dell PowerEdge R760 Installation And Service Manual

iDRAC Quick Sync 2 indicator codes

iDRAC Quick Sync 2 module (optional) is located on the left control panel front IO panel of the system.
Table 161. iDRAC Quick Sync 2 indicators and descriptions
iDRAC Quick Sync 2 indicator
code
Off (default state)
Solid white
Blinks white rapidly
Blinks white slowly
Blinks white five times rapidly
and then powers off
Solid amber
Blinking amber

iDRAC Direct LED indicator codes

The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC
subsystem.
You can configure iDRAC Direct by using a USB to micro USB (type AB) cable, which you can connect to your laptop or
tablet. Cable length should not exceed 3 feet (0.91 meters). Performance could be affected by cable quality. The following table
describes iDRAC Direct activity when the iDRAC Direct port is active:
Table 162. iDRAC Direct LED indicator codes
iDRAC Direct LED
indicator code
Solid green for two
seconds
Blinking green (on for
two seconds and off for
two seconds)
Condition
Indicates that the iDRAC Quick Sync 2
feature is powered off. Press the iDRAC
Quick Sync 2 button to power on the
iDRAC Quick Sync 2 feature.
Indicates that iDRAC Quick Sync 2 is
ready to communicate. Press the iDRAC
Quick Sync 2 button to power off.
Indicates data transfer activity.
Indicates that firmware update is in
progress.
Indicates that the iDRAC Quick Sync 2
feature is disabled.
Indicates that the system is in fail-safe
mode.
Indicates that the iDRAC Quick Sync 2
hardware is not responding properly.
Condition
Indicates that the laptop or tablet is connected.
Indicates that the laptop or tablet connected is recognized.
Corrective action
If the LED fails to power on, reseat the left
control panel flex cable and check. If the problem
persists, see the Getting help
If the LED fails to power off, restart the system.
If the problem persists, see the
section.
If the indicator continues to blink indefinitely, see
the Getting help section.
If the indicator continues to blink indefinitely, see
the Getting help section.
Check if iDRAC Quick Sync 2 feature is
configured to be disabled by iDRAC. If
the problem persists, see the
section. www.dell.com/poweredgemanuals
OpenManage Server Administrator User's Guide
at https://www.dell.com/openmanagemanuals.
Restart the system. If the problem persists, see
the Getting help section.
Restart the system. If the problem persists, see
the Getting help section.
System diagnostics and indicator codes
section.
Getting help
Getting help
or Dell
321