Figure 62. Removing the 2 x 2.5-inch rear drive module
Next steps
1.
Replace the 2 x 2.5-inch rear drive
Installing the 2 x 2.5-inch rear drive module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If required,
remove the air
4.
Remove the
drives.
5. Disconnect the cables from the rear drive module.
NOTE:
Refer to
cable routing
Steps
1. Align the slot on the rear drive module with the guide on the system.
2. Lower and press the rear drive module on top of the riser until firmly seated.
3. Using a Phillips #2 screwdriver, tighten the captive screws that secure the rear drive module into the system.
112
Installing and removing system components
module.
Safety
instructions.
Before working inside your
shroud.
section for more information.
system.