Table of Contents
Advertisement
Figure 221. Installing the BOSS-N1 card carrier blank
Removing the BOSS-N1 module
The removal of the BOSS-N1 module from the Riser 1 and 4 x 2.5-inch rear drive module is similar.
Prerequisites
1. Follow the safety guidelines listed in the
Safety
instructions.
2. Follow the procedure listed in the
Before working inside your
system.
Steps
1. Pull and lift the BOSS-N1 card carrier retention latch lock to open.
2. Slide the BOSS-N1 card carrier out.
Installing and removing system components
275
- Quick Links:
- Front View of the System
Hide quick links:
Advertisement
Table of Contents
