Control Panel; Removing The Right Control Panel - Dell PowerEdge R760 Installation And Service Manual

Figure 252. Installing the LOM card and Liquid cooling rear I/O board
Next steps
1. Install the system board.
2. Follow the procedure listed in

Control panel

This is a service technician replaceable part only.

Removing the right control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
4. If installed, remove the air shroud
5. Remove the cooling fan cage
6. Remove the side wall
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secure the right control panel and cable cover to the system.
2. Remove the cable cover away from the system.
3. Disconnect the right control panel cable and the VGA cable from the connectors on the system board.
4. Holding the right control panel and VGA cable assembly, slide the right control panel out of the system.
NOTE: Observe the routing of the cable assembly as you remove the right control panel from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
After working inside your
Safety
Before working inside your
cover.
or remove the GPU air
assembly.
bracket.
system.
instructions.
system.
shroud.
Installing and removing system components 301