Optional Boss S2 Card; Removing The Boss S2 Module - Dell EMC PowerEdge E75S Series Installation And Service Manual

3. Press the IDSDM module, until firmly seated on the system board connector.
Figure 73. Installing the IDSDM module
Next steps
1. Install the MicroSD cards.
NOTE: Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2. Follow the procedure listed in the

Optional BOSS S2 card

Removing the BOSS S2 module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If required, remove the air
Steps
1. Pull and lift the BOSS S2 card carrier retention latch lock to open.
2. Slide the BOSS S2 card carrier out.
82 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
shroud.
system.
system.