Optional Serial Com Port; Removing The Serial Com Port - Dell PowerEdge R760 Installation And Service Manual

Optional serial COM port

This is a service technician replaceable part only.

Removing the serial COM port

The procedure to remove serial COM port from Riser 3 or 4 is same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud
4. If required, remove PCIe card from slot 7.
NOTE: The serial COM port is supported only in slot 4 or slot 8 of the expansion card riser.
Steps
1. Loosen the captive screws on the system.
2. Press the blue release tab or blue button on the riser and holding the edges lift the expansion card riser from the riser
connector on the system board.
3. Disconnect the serial COM port cable from the rear I/O board.
Figure 210. Disconnecting the serial COM port
4. Open the latch on the expansion card riser and slide the serial COM port out of the expansion card riser.
266 Installing and removing system components
Safety instructions.
Before working inside your
or remove the GPU air shroud.
system.