Removing The Processor - Dell PowerEdge R760 Installation And Service Manual

Figure 137. Removing a heat sink
Next steps
If you are removing a faulty heat sink,

Removing the processor

Prerequisites
WARNING: Remove the processor from processor and heat sink module (PHM) only if you are replacing the
processor or heat sink.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud
4. Remove the processor heat sink
CAUTION: You may find the CMOS battery loss or CMOS checksum error that is displayed during the first
instance of powering on the system after the processor or system board replacement which is expected. To fix
this, simply go to setup option to configure the system settings.
Steps
1. Place the heat sink with the processor side facing up.
2. Using your thumb, lift the thermal interface material (TIM) break lever to release the processor from the TIM and retaining
clip.
3. Holding the processor by the edges, lift the processor away from the retaining clip.
NOTE: Ensure to hold the retaining clip to the heat sink as you lift the TIM break lever.
replace the heat
Safety instructions.
Before working inside your
or remove the GPU air shroud.
module.
sink, if not, remove the processor.
system.
Installing and removing system components 183