Perc Module; Removing The Rear Mounting Front Perc Module - Dell PowerEdge R760 Installation And Service Manual

Figure 126. Configuration 50: BOSS-N1 module in 4 x 2.5-inch rear drive module
NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 129. BOSS-N1 module in 4 x 2.5-inch rear drive module
Order
1
2
NOTE: The BOSS-N1 signal cable is routed beneath rear drive module and ensure not to damage the cable.

PERC module

This is a service technician replaceable part only.

Removing the rear mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the cooling fan cage
4. Remove the drive backplane
5. If required, remove the air shroud
6. Disconnect all the cables, observe the cable routing.
NOTE: Refer to cable routing
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the rear mounting front PERC module.
172 Installing and removing system components
From
BOSS_PWR_MB (BOSS power connector on
system board)
SL12_PCH_PA6 (signal connector on system
board)
Safety instructions.
Before working inside your
assembly.
cover.
or remove the GPU air
section for more information.
To
BOSS_PWR (BOSS module power
connector)
BOSS (BOSS module signal connector)
system.
shroud..