Table of Contents
Advertisement
Figure 34. Installing the BOSS-N1 card
Next steps
Follow the procedure listed in
After working inside your
system.
Removing the M.2 SSD module from the BOSS-N1 card
Prerequisites
1. Follow the safety guidelines listed in
Safety
instructions.
2. Follow the procedure listed in
Before working inside your
system.
Steps
1. Remove the screw that is on the BOSS-N1 card using Philips 2 screwdriver.
2. Pull the M.2 SSD module from the M.2 slot on the BOSS-N1 card.
64
Installing and removing system components
Advertisement
Table of Contents
